2021-2025 Guide

Chevrolet Silverado 1500 Tire Pressure Light Reset

Follow the TPMS reset procedure for 2021-2025 Chevrolet Silverado 1500 models.

Before You Start

Tires must be cold for accurate pressure adjustment.

The parking brake must be set when performing the TPMS relearn procedure.

TPMS Reset Procedure

Adjust all tires to the pressure listed on the driver's door jamb sticker.

Drive the vehicle above 20 mph (32 km/h) for several minutes. The system should detect the updated tire pressures and turn off the warning light automatically.

If the warning light remains on or the tires were rotated, turn the ignition to ON/RUN with the engine off.

Use the steering wheel controls to navigate to the Tire Pressure menu on the instrument cluster.

Press and hold the Thumbwheel (Select) button until the horn chirps twice and the message 'Tire Learning Active' appears.

Starting with the Driver's Side Front tire, increase or decrease the tire pressure for about 10 seconds until the horn chirps. Continue clockwise through the Front Right, Rear Right, and Rear Left tires until the final horn chirp confirms the relearn is complete.

Warning: The 'Tire Learning Active' mode will time out after 2 minutes of inactivity.

Warning: If the TPMS warning light flashes for about 60 seconds before remaining illuminated, a TPMS sensor battery may have failed.

Notes

Note: 2022-2025 models with the fully digital instrument cluster use the right-side steering wheel thumbwheel.

Note: Models equipped with the 13.4-inch screen may also display individual tire pressures in the Vehicle Status app.

Chevrolet Silverado 1500 TPMS Reset

This guide covers the TPMS sensor relearn procedure for the 2019-2020 Chevrolet Silverado 1500.

The Silverado 1500 can enter a tire learning mode that allows the vehicle to match each wheel’s TPMS sensor to its position.

Before You Start

Set the parking brake and verify that all tires are inflated to the cold pressure listed on the vehicle’s B-pillar or driver’s door jamb sticker.

If you are using the air-pressure change method rather than a dedicated TPMS relearn tool, perform the procedure somewhere quiet enough to hear the horn chirps.

TPMS Sensor Relearn Procedure

Turn the ignition to ON/RUN with the engine off.
Use the steering wheel thumbwheel to find the Tire Pressure page in the Driver Information Center.
Press and hold the thumbwheel or Select button until the horn chirps twice and Tire Learning Active appears.
Start with the Driver Side Front tire. Increase or decrease its pressure for approximately 10 seconds until the horn chirps once.
Continue clockwise: Front Right -> Rear Right -> Rear Left, waiting for the horn chirp after each tire.
After the Rear Left tire is matched, listen for two additional horn chirps indicating that the relearn is complete.
Turn the ignition off and return all tires to the recommended cold tire pressure.